Net-optics Director Bedienungsanleitung PDF herunterladen (Seite 26)

Director

Connect Span Ports to Director

To connect Director to the network using Span ports, be sure that at least one of your DNMs is a Span model. Use ports

in that DNM to connect to the network.

Span port numbering is shown in the following diagram. It is the same for Span DNMs and in-line DNMs.

www.netoptics.com

™

Director

A B

Span

10/100/1000

100

1000

LINK

ACT

Port # n2.1 .2 .3 .4 .5 . 6

Port # n2.7 .8 .9 .10 .11 .12

Span

GigaBit

1 2 3 4 5 6 7 8 9 10 11 12

Port numbers in purple

Port # n1.1 .2 .3 .4 .5 . 6

Port # n1.7 .8 .9 .10 .11 .12

Port numbering for Span DNM modelsFigure 18:

Note: __________________________________________________________________________________________________

DNM 1 is on the left and DNM 2 is on the right. In the CLI, the Network ports are designated using the letter "n"

followed by the DNM number, a dot, and then the port number. For example, the Network port on the upper left is n1.1

and the Network port on the lower right is n2.12.

________________________________________________________________________________________________________

To connect a Span port:

Plug the appropriate cable into a Director Span port.1.

Plug the other end of the cable into the Span port of the switch. The Link LED for the port illuminates after a short 2.

delay to indicate that a link has been established. If the trafc if owing from the Span port, two Link LEDs blink.

Repeat for all desired Span port connections.

www.netoptics.com

™

Director

A B

Spn

10/100/1000

100

1000

LINK

ACT

Span

GigaBit

1 2 3 4 5 6 7 8 9 10 11 12

Span port connectionsFigure 19:

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 58 59

Kommentare zu diesen Handbüchern

Keine Kommentare

Net-optics Director Bedienungsanleitung Seite 26

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computerzubehör Net-optics Director